Treadmill fault code and solution list

Time:2013-06-10 03:53:48

Ai Keduo treadmill fault code and solution list fault code reason solution method E01 electronic watch and controller communication failure 1. Check if the main line interface is in poor contact, otherwise the main line must be replaced. Replace the controller (lower control) 3. Replace the electronic watch E02 explosion-proof protection 1. Check the motor connection terminal (see if the motor is connected to the lower control line). Replace the motor 3. Replace the controller (ie, under control, the possibility is small) E03 speed sensing failure 1. Replace the speed sensor, (ie light perception) 2. The speed sensor is not installed and the position is re-adjusted. 3. Replace the controller (lower control) E05 overcurrent protection 1. Replace the motor 2. Check the motor connection terminal 3. Replace the controller (lower control) E06 controller power on self test error 1. Replace the controller (lower control) E071. Not placed 2. Replace the electronic watch E081. Replace the controller (lower control) ------ No safety lock placed Safety lock speed Slow and slow Speed sensor damage Replace the speed sensor (ie light sense) black screen, no If the electronic watch is not powered, check whether the main line interface is in poor contact. Otherwise, replace the main line 2 and replace the controller (lower control) 3. If the transformer is separated from the lower control, consider changing the transformer 4 and checking whether the power switch is turned on. If the power cord is in poor contact, the power-on speed will automatically increase the corresponding button of the electronic watch or the handle of the speed button. 1 Check the speed of the electronic watch or the corresponding speed. The direct key is pressed. 2. Check whether the speed of the handle is pressed or not. Otherwise, The speed must be very slow after changing the power on. The speed does not go to the corresponding button of the electronic watch or the handle speed button fails. 1 Check whether the speed of the electronic watch is reduced or the corresponding speed direct selection key is dead. 2. Check whether the speed of the handle is reduced. Press dead, otherwise you need to replace the start button, the electronic watch speed display 0, does not start, no fault code shows the stop button on the electronic watch or the handle stop button is out of order 1, check whether the stop button on the electronic watch is dead, 2, check the handle to stop Whether the button is pressed or not, otherwise it must be replaced